Installation; Assemble The Proportioner; Mount The System - Graco Reactor 2 E-30 Operation

Installation

Installation
Installation Installation
Assemble Assemble the Assemble the Proportioner the Proportioner Proportioner
Reactor 2 proportioners arrive in a shipping
configuration. Before mounting the system,
assemble the proportioner in the upright
position.
1. Remove bolts (A) and nuts.
2. Swing the electrical enclosure upright.
3. Reinstall bolt (A) with nut. Tighten bolt (B)
and nut.
4. Position the cable bundles against the frame.
Attach the bundles to the frame with a loose
wire tie (C) on each side.
26
Mount the the System System
Mount Mount the System
To prevent serious injury due to system
tipping over, ensure Reactor is properly
secured to wall.
NOTE: Mounting brackets and bolts are included
NOTE: NOTE:
in the box of loose parts, shipped with your
system.
1. Use the supplied bolts to install the supplied
L-brackets onto the system frame in the
top-most square holes. Install brackets on
both the left and right side of system frame.
2. Secure the L-brackets to the wall. If
L-brackets do not line up with the wall stud
spacing, bolt a piece of wood to the studs
then secure L-brackets to wood.
333023U