Graco Reactor 2 E-30 Operation page 43

Diagnostic Diagnostic Screen Diagnostic Screen Screen
Use this screen to view information for all
system components.
The following information is displayed:
Temperature
Temperature Temperature
• A Chemical
• B Chemical
• Hose Chemical
• TCM PCB — temperature control module
temperature
Amps
Amps Amps
• A Current H(0–25 A for 10kW heater, 0–38 A
for 15 kW heater)
• B Current H(0–25 A for 10kW heater, 0–38 A
for 15 kW heater)
• Hose Current H(0–45 A typical)
Volts Volts Volts
• MCM BusH — displays the voltage supplied to
the motor controller, which is the DC voltage
that has been converted from the AC voltage
supplied to the system (275–400 V typical full
range)
• A Voltage – Voltage supplied to A heater
(195–240 V typical)
• B Voltage – Voltage supplied to B heater
(195–240 V typical)
• Hose Voltage (90V)
Pressure Pressure Pressure
• Pressure A — chemical
• Pressure B — chemical
333023U
Advanced Display Module (ADM) Operation
Cycles
Cycles Cycles
• CPM — cycles per minute
• Total Cycles — lifetime cycles
NOTE: H Maximum values based on maximum NOTE: NOTE:
input voltage. Values will lower with lower input
voltage.
Job Job Data Job Data Screen Data Screen Screen
Use this screen to enter a job name or number.
Recipes Screen Screen
Recipes Recipes Screen
Use this screen to select an enabled recipe. Use
the up and down arrows to highlight a recipe
and press to load. The currently loaded
recipe is outlined by a green box.
NOTE: This screen will not display if there are
NOTE: NOTE:
not any enabled recipes. To enable or disable
recipes, see Recipes Setup Screen, page 37.
43