Operation - Graco Reactor 2 E-30 Operation

Advanced Display Module (ADM) Operation
Advanced Display Display Module
Advanced Advanced Display
When main power is turned on by turning the
main power switch (MP) to the ON position,
the power up screen will be displayed until
communication and initialization is complete.
Then the power key icon screen will display until
the ADM power on/off button (A)
for the first time after system power-up.
To begin using the ADM, the machine
must be active. To verify the machine
is active, verify that the System Status
Indicator Light (B) is illuminated green, see
Advanced Display Module (ADM), page
the System Status Indicator Light is not green,
press the ADM Power On/Off (A) button
The System Status Indicator Light will illuminate
yellow if the machine is disabled.
32
Module (ADM) (ADM) Operation
Module (ADM)
If Hose Resistance Mode is enabled, a reminder
prompt will appear when the ADM becomes
active.
Press the Continue soft key
screen.
is pressed
Perform the following tasks to fully setup your
system.
1. Set pressure values for the Pressure
Imbalance Alarm to activate. See
System Screen 1, page
18. If
2. Enter, enable, or disable recipes. See
Recipes Screen, page
.
3. Set general system settings. See
Advanced Screen 1 — General, page
4. Set units of measure.
Advanced Screen 2 — Units, page
5. Set USB settings.
Advanced Screen 3— USB, page
6. Set target temperatures and pressure. See
Targets, page
7. Set component A and component B supply
levels. See

Operation

Operation
to clear the
36.
37.
See
See
40.
Maintenance, page 40.
35.
35.
35.
333023U