Proportioner - Graco Reactor 2 E-30 Operation

Connect Heated Heated Hose
Connect Connect Heated

Proportioner

Proportioner Proportioner
NOTICE
NOTICE NOTICE
To avoid damage to the hose, only connect
Reactor 2 proportioners to genuine Graco
heated hoses.
Refer to your heated hose manual for detailed
connection instructions.
1. Turn off main power switch (MP).
2. For proportioners with termination box (TB):
a. Connect hose power wires to terminal
block (T) on termination box (TB).
Remove box cover and loosen lower
strain relief (E). Route hose wires (V)
through the box strain relief and fully
insert into terminal block (T). A and B
hose wire positions are not important.
Torque to 35–50 in-lb (4.0–5.6 N·m).
b. Fully tighten strain relief screws and
replace cover.
Figure 11 Termination Box
333023U
Hose to to to
Hose
3. For proportioners with electrical splice
connectors (S):
a. Connect hose power wires to electrical
splice connectors (S) from proportioner.
Wrap connections with electrical tape.
Figure 12 Electrical Splice Connectors
4. Connect FTS cable connectors (R). Fully
tighten RTD connectors, if provided.
Setup
31