System Operation; Operation Modes; Sequential Dosing; Dynamic Dosing - Graco ProMix 2KS Operation

System Operation

System Operation

Operation Modes

Mix
System mixes and dispenses material.
Standby
Stops the system.
Purge
Purges the system, using air and solvent.

Sequential Dosing

Components A and B dispense sequentially in the nec-
essary volumes to attain the mix ratio.

Dynamic Dosing

In typical operation (ratios 1:1 and above), component A
dispenses constantly. Component B dispenses intermit-
tently in the necessary volume to attain the mix ratio.

Recipe (Color) Change

The process when the system automatically flushes out
the old color and loads a new color.
42
General Operating Cycle,
Sequential Dosing
1. The spray gun operator enters and loads the
desired recipe. The color change LED blinks while
recipe is loading, then turns solid when complete.
2. The operator presses the Mix
operation.
3. The ProMix 2KS controller sends signals to activate
the solenoid valves. The solenoid valves activate
Dose Valves A and B. Fluid flow begins when the
gun is triggered.
4. Components A and B are introduced into the fluid
integrator (FI) one at a time as follows.
a. Dose Valve A (DVA) opens, and fluid flows into
the integrator.
b. Flow Meter A (MA) monitors the fluid volume
dispensed and sends electrical pulses to the
ProMix 2KS controller. The controller monitors
these pulses and signals.
c. When the target volume dispenses, Dose Valve
A closes.
NOTE: The dispense volume of component A and B
is based on the mix ratio and dose size set by the
user and calculated by the ProMix 2KS controller.
d. Dose Valve B (DVB) opens, and fluid flows into
the integrator and is aligned proportionately with
component A.
e. Flow Meter B (MB) monitors the fluid volume
dispensed and sends electrical pulses to the
ProMix 2KS controller.
f. When the target volume is dispensed, Dose
Valve B closes.
key to begin
312776B