Installation - KEB COMBIVERT F6 Series Instructions For Use Manual

bASIC SAFETy INSTRUCTIONS
ESD
Do not store drive controllers
•
•
•

1.3 Installation

DANGER
EX
CAUTION
To prevent damages to the device:
•
•
•
•
•
•
•
•
•
•
Drive controllers contain electrostatic sensitive components.
► Avoid contact.
► Wear ESD-protective clothing.
in the environment of aggressive and/or conductive liquids or gases.
with direct sunlight.
outside the specified environmental conditions.
Do not operate in an explosive environment!
► The COMBIVERT is not intended for the use in potentially explosive
environment.
Design-related edges and high weight!
Contusions and bruises!
► Never stand under suspended loads.
► Wear safety shoes.
► Secure drive controller accordingly when using lifting gear.
Make sure that no components are bent and/or isolation distances are changed.
The device must not be put into operation in case of mechanical defects.
Do not allow moisture or mist to penetrate the unit.
Avoid dust permeating the device. Allow for sufficient heat dissipation if installed in
a dust-proof housing.
Note installation position and minimum distances to surrounding elements. Do not
cover the ventilation openings.
Mount the drive controller according to the specified degree of protection.
Make sure that no small parts fall into the COMBIVERT during assembly and wiring
(drilling chips, screws etc.). This also applies to mechanical components, which can
lose small parts during operation.
Check the reliable fit of the device connections in order to avoid contact resistances
and sparking.
Do not walk-on drive controller.
Follow all safety instructions!
15