Honda SH125 Manual page 266

FRONT WHEEL/SUSPENSION/STEERlNG
Make sure to pull
the fork leg up into
the spring seat.
Coat a new O-ring with fork fluid and install it into
the spring seat groove.
Install the spring seat, spacer and joint plate.
Set the fork leg, spring seat and stopper ring onto a
hydraulic press.
Press the spring seat until the stopper ring groove is
visible.
Do
not compress the fork spring more than neces-
sary.
Install the fork tube cap.
INSTALLATION
Install the fork leg into the fork bridge and align the
fork tube groove with the bolt hole, then install the
upper mounting bolt.
Tighten the two mounting bolts securely.
Install the following:
-
front wheel (page 14-11)
-
front fender (page 2-8)
Left fork only:
Install the brake caliper with new mounting bolts
and tighten the bolts.
TORQUE: 30 N-m (3.1 kgfam, 22 Ibf-ft)
Install the brake hose clamp and tighten the bolt.