Installation - Honda SH125 Manual

CYLINDER HEADNALVES
CAMSHAFJIROCKER ARM
I NSTALLATI 0 N
CAMSHAFT HOLDER ASSEMBLY
Clean the rocker arm shaft holes and camshaft bear-
ing mating areas.
Blow out the oil passage (stud bolt hole) in the cam-
shaft holder with compressed air.
Install the camshaft and the snap ring with the
chamfered (rolled) edge facing the bearing side.
Apply engine oil to the bearings.
Do
not exchange
Apply engine oil to the sliding surface of the rocker
the intake and
arm and shaft. Place the rocker arms into the head
exhaustrockerarm
cover in the direction as shown, and install the
shafts.
rocker arm shafts with the thread ends facing the
sprocket side.
Install each snap ring into the camshaft holder
groove with the chamfered (rolled) edge facing the
rocker arm side.
CAMSHAFT HOLDER INSTALLATION
Be careful not to
Clean the mating surfaces of the camshaft holdeF
damage the mating
and cylinder head thoroughly.
Install the two dowel pins.
surfaces.
8-24