Engine Oil - Honda SH125 Manual

MAINTENANCE
When checking the
Check the clearances of each valve by inserting the
clearance, slide the
feeler gauge between the adjusting screw and
feeler gauge from
rocker arm.
the Inside out in the
djrection of the
VALVE CLEARANCE:
arrow.
IN: 0.16 f 0.02 mm (0.006 f 0.001 in)
EX: 0.25
k
0.02 mm (0.010
f
0.001 in)
Apply engine oil to
Adjust by loosening the lock nut and turning the
thelocknut
adjusting screw until there is a slight drag o n the
Hold the adjusting screw and tighten the lock nut.
TORQUE: 10 Nnm (1.0 kgfm, 7 Ibf.ft)
After tightening the lock nut, recheck the valve
clearance.
threads.
feeler gauge.
Coat a new O-ring with engine oil and install it onto
the timing hole cap.
Install the cap and tighten it.
TORQUE: 6 N.m (0.6 kgf.m, 4.4 Ibf4t)
Install the following:
-
cylinder head cover (page 8-27)
-
belt case air cleaner housing (page 3-13)
ENGINE OIL
NOTE:
For engine oil change procedure, see page 3-9
"Engine Oil Strainer Screen".
OIL LEVEL CHECK
Place the scooter o n its center stand o n a level sur-
face.
Start the engine and let it idle for 3
-
5 minutes.
Stop the engine and wait for 2
-
3 minutes.
Remove the oil filler cap/dipstick and wipe the oil
fro m the dipstick with a clean cloth.
Insert the filler cap/dipstick without screwing it in,
remove
it
and check the oil level.
The level should be between the upper and lower
level lines o n the dipstick.
3-8