Honda SH125 Manual page 337

LIGHTS/METERS/SWITCHES
ITEM
Bulb Headlight (high/low beam)
Brakehailliaht
SERVICE INFORMATION
m
GENERAL
SPECIFICATIONS
12 V
-
60155 W
12 V
-
2115 W
Note the following when replacing the halogen headlight bulb.
-
Wear clean gloves while replacing the headlight bulb. Do not put fingerprints
on
the headlight bulb, as they may create
hot spots on the bulb and cause it to fail.
-
If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
A
halogen headlight bulb becomes very hot while the headlight is on, and remains hot for a while after it is turned off.
Be sure t o let it cool down before servicing.
Be sure to install the dust cover after replacing the bulb.
Use an electric heating element to heat the water/coolant mixture for the ECT sensor inspection. Keep all flammable
materials away from the electric heating element. Wear protective clothing, insulated gloves and eye protection.
Check the battery condition before performing any inspection that requires proper battery voltage.
A continuity test can be made with the switches installed on the scooter.
The following color codes used are indicated through out this section.
Bu: Blue G: Green Lg: Light Green W: White
El: Black Gr: Gray 0: Orange Y Yellow
Br: Brown Lb: Light Blue R: Red
Turn signal light
Position light
Instrument light
Hiah beam indicator
1 2 v - 2 1 w x 4
1 2 v - 5 w x 2
12
v
-
1.7
w
x 3
12 V
-
1.7 W
Fuse
Y
Turn signal indicator 12 V
-
1.7 W x 2
PGM-FI malfunction indicator LED
Engine oil maintenance indicator LED
Main fuse 30
A
Sub-fuse 1 5 A x 1 , 1 0 A x 4
TORQUE VALUES
License light screw
Speedometer cable joint nut
1.5 N.m (0.15 kgf.m, 1.1 Ibf.fi)
3.4 N.m (0.35 kgf.m, 2.5 Ibfeft)
20-3