Honda SH125 Manual page 260

FRONT WHEEL/SUSPENSION/STEERlNG
Install the axle nut and tighten it.
TORQUE: 68 N.m (6.9 kgf-m, 50 Ibf-ft)
Coat a new O-ring with grease and install it into the
cable groove.
Connect the speedometer cable by aligning the
groove with the blade.
Install the setting screw and tighten
it.
TORQUE: 2.2 N.m (0.22 kgf.m, 1.6 Ibf.ft)
With the front brake applied, pump the suspension
up and down several times and check brake opera-
tion.
FORK
REMOVAL
Support the brake
Remove the following left fork:
caliper so it does
-
bolt and brake hose clamp
not hang from the
-
two bolts and brake caliper
brake hose.
Remove the front fender (page 2-8).
Remove the front wheel (page 14-7).
twist the brake
hose.
Remove the upper mounting bolt.
Loosen the lower mounting bolt and remove the
fork leg.
14-12