Danfoss Turbocor TT Series Service Manual page 190

Figure 4-212 Seated Spring Pins
2. There are two (2) different length spring pins, if any are replaced, be sure to replace with the same
Figure 4-213 Spring Locations
Table 4-35 Spring Identification
Spring Numbers
Springs 1-6
Springs 7-13
Page 190 of 294 - M-SV-001-EN Rev. H 1/23/2023
length spring pin. Refer to Figure 4-213 S pring Locations and Table 4-35 S pring Identification for the
locations of the long and short spring pins. For an example of the difference between the two (2)
different spring pin lengths, refer to Figure 4-214 S pring Pin Identification on page 191.
Length
Short
Long