Danfoss Turbocor TT Series Service Manual page 172

4. Remove the nylon nuts at the base of the DC Capacitor Bus Bar Assembly, under the main compressor
Figure 4-186 Capacitor Nut Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
5. Carefully lift the DC Bus Bars and capacitors out as an assembly. Do not remove the bleed resistors,
Bleed Resistors and bus bars may have sharp edges. Use caution and wear appropriate protective gear when removing the capacitor
assembly.
Page 172 of 294 - M-SV-001-EN Rev. H 1/23/2023
housing. Refer to Figure 4-186 C apacitor Nut Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230).
Balance Board, or capacitors from the bus bars. Refer to Figure 4-187 C apacitor Assembly Removal -
TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230) on page 173 and Figure 4-188 C apacitor
Assembly Removal - TTS/TGS/TTH/TGH Rev. H (Except TTS300/TGS230) on page 173.
• • • DANGER! • • •