Figure 4-180 Snubber Capacitor Removal - TTS300/TGS230
4. Remove the nylon nuts at the base of the DC Capacitor Bus Bar Assembly, under the main compressor
Figure 4-181 Capacitor Nut Removal - TTS300/TGS230
5. Carefully lift the DC Bus Bars and capacitors out as an assembly. Do not remove the bleed resistors or
Bleed Resistors and bus bars may have sharp edges. U se caution and wear appropriate protective gear when removing the capacitor
assembly.
housing. Refer to Figure 4-181 C apacitor Nut Removal - TTS300/TGS230.
capacitors from the bus bars. Refer to Figure 4-182 C apacitor Assembly Removal - TTS300/TGS230 on
page 170.
• • • DANGER! • • •
M-SV-001-EN Rev. H-1/23/2023 Page 169 of 294