17. Slide out all three (3) Inverter Copper Tubes.
Figure 4-201 Inverter Copper Tube Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
18. Remove the upper half of the compressor cable harness. R efer to Section 4.5.2 C ompressor Controller
19. Remove the SCR Cooling Manifold. Refer to Section 4.19.3 S CR Cooling Manifold Specific Removal Steps
20. Remove the Inverter cable harness from the top of the Inverter. Refer to Figure 4-202 I nverter Harness
Figure 4-202 Inverter Harness Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
21. Remove the DC-DC from the Inverter Heat Sink Plate. Refer to Section 4.24.3 D C-DC Removal and
22. Disconnect the wires from the Motor Winding Sensor. Refer to Figure 4-203 M otor Winding Sensor
Cable Harness Removal and Installation on page 68.
- TTS/TGS/TTH/TGH (Except TTS300/TGS230) on page 159.
Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230).
Installation on page 206.
Removal.
M-SV-001-EN Rev. H-1/23/2023 Page 183 of 294