Danfoss Turbocor TT Series Service Manual page 181

Figure 4-197 Motor Winding Sensor Connector Removal
9. Remove the upper half of the compressor cable harness. Refer to Section 4.5.2 C ompressor Controller
10. Remove the 20 M6x30 fasteners that secure the Inverter to the compressor main housing and carefully
Figure 4-198 Inverter Assembly Removal - TTS300/TGS230
The SCRs do not need to be removed from the SCR Cooling Manifold when removing the Inverter.
11. Remove the SCR Cooling Manifold. Refer to Section 4.19.2 S CR Cooling Manifold Specific Removal Steps
Cable Harness Removal and Installation on page 68.
remove the Inverter and remove and discard the two (2) O-rings underneath.
- TTS300/TGS230 on page 157.
NOTE
M-SV-001-EN Rev. H-1/23/2023 Page 181 of 294