Danfoss Turbocor TT Series Service Manual page 92

Figure 4-66 IGV Motor Alignment
16. Put one (1) drop of threadlocker (Loctite 243 blue or equivalent) on the threads of the small set screw.
17. Clean, lubricate, and install the O-ring on the Feedthrough before connecting the wires.
18. Insert the motor wires onto the Feedthrough pins in accordance with Table 4-15 I GV Feedthrough
The colors associated with each pin could vary, so be sure to refer to notes taken during removal.
Table 4-15 IGV Feedthrough Wiring Order
Page 92 of 294 - M-SV-001-EN Rev. H 1/23/2023
While pushing in, on the backside of the motor, secure the worm gear set screw to the flat surface of
the motor shaft using a 2.5 mm hex bit. Rock the motor backwards and forwards while tightening to
ensure full and correct engagement of the screw to the flat of the motor shaft. Torque the set screw to
5Nm (44 in.lb.). Refer to Figure 4-64 I GV Worm Gear Alignment on page 91.
Wiring Order. Also reference your notes from removal.
Color
Red
Gray
Yellow
Black
NOTE
Pin #
1
2
3
4