Danfoss Turbocor TT Series Service Manual page 120

Figure 4-104 Open-Top Soft Start J7 Connector
3. Disconnect the Soft Start ground wire by removing the nut and mains input ground wire from the
Figure 4-105 Ground Location
4. Unplug cable connectors J1, J2, and J8 from the Soft Start.
Page 120 of 294 - M-SV-001-EN Rev. H 1/23/2023
ground post on the compressor housing at 3 phase connection point. Refer to Figure 4-105 G round
Location.