Figure 4-173 Inverter Heat Sink Plate O-ring Installation - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
3. Clean the O-ring grooves in the SCR Manifold Return Brass Fitting with a lint-free cloth.
4. Install two (2) new O-rings on the SCR Manifold Return Brass Fitting (smaller one on top). Apply O-lube
Figure 4-174 SCR Manifold Return Brass Fitting O-ring Installation - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
5. Carefully install the SCR Cooling Manifold over the SCR Manifold Return Brass Fitting. Press down firmly
6. Install the four (4) M6x35 SCR Cooling Manifold fasteners and torque to 7 Nm (62 in. lb.).
to each O-ring before installation. Refer to Figure 4-174 S CR Manifold Return Brass Fitting O-ring
Installation - TTS/TGS/TTH/TGH (Except TTS300/TGS230).
to ensure proper seating of the O-rings into the plate.
M-SV-001-EN Rev. H-1/23/2023 Page 161 of 294