Danfoss Turbocor TT Series Service Manual page 158

Figure 4-169 Inverter Assembly Removal - TTS300/TGS230
Figure 4-169 I nverter Assembly Removal - TTS300/TGS230 shows the SCRs still mounted on the cooling plate. It is recommended that they
are removed prior to the removal of the SCR Cooling Manifold.
7. Carefully peel back the foam to gain access to the two (2) M6x20 fasteners. Remove the two (2) SCR
8. Remove and discard the two (2) O-rings.
Figure 4-170 SCR Cooling Manifold Removal - TTS300/TGS230
Page 158 of 294 - M-SV-001-EN Rev. H 1/23/2023
Cooling Manifold fasteners and remove the assembly. Refer to Figure 4-170 S CR Cooling Manifold
Removal - TTS300/TGS230 for this and the following step.
NOTE