Danfoss Turbocor TT Series Service Manual page 139

4. Install the -DC and +DC spade terminals onto the DC bus bar.
5. Install the L1, L2, and L3 terminals to the AC Bus Bars.
Figure 4-137 AC Input and Spade Connector Installation - TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230)
Figure 4-138 AC Input and Spade Connector Installation - TTS/TGS/TTH/TGH Rev. H (Except TTS300/TGS230)
b. If the DC-DC is the open-frame style, only J1 will need to be installed. Refer to Figure 4-130 D C-DC
Connectors (Open Frame) on page 134.
a. For Revision F and earlier compressors refer to Figure 4-137 A C Input and Spade Connector
Installation - TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230).
b. For Rev H compressors, refer to Figure 4-138 A C Input and Spade Connector Installation -
TTS/TGS/TTH/TGH Rev. H (Except TTS300/TGS230).
a. For Revision F and earlier compressors, refer to Figure 4-137 A C Input and Spade Connector
Installation - TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230).
b. For Rev H compressors, refer to Figure 4-138 A C Input and Spade Connector Installation -
TTS/TGS/TTH/TGH Rev. H (Except TTS300/TGS230).
M-SV-001-EN Rev. H-1/23/2023 Page 139 of 294