Operation; Double Doors - Assa Abloy Norton 5900 Series Installation And Instruction Manual

Operation:

Your 5900 Series Operator can be configured in two variations to meet the standards:
1. Push plates are provided to activate the operator. The door also can be used as a manual door.
2. Push to activate can be enabled. In this mode, your door is pushed (or pulled) 5° manually, and
then automatically opens to full open position.
If desired, overhead presence devices can be provided for an extra level of protection. These are not
required by current ANSI/BHMA A156.19 codes.
Opening:
When an opening signal is received by the control unit, the door is opened at the operator-adjusted opening
speed. Before the door is fully open at backcheck, it slows automatically to low speed. The motor stops when
the selected door opening angle has been reached. The open position is held by the motor.
If the door is obstructed while opening, it will either stall or stop which can be selected with a DIP switch.
* When stalling - the door will continue to try to open during the hold open time.
* When stopping - the door will, even if hold open time has not expired, close after 2 seconds.
Closing:
The door shall not close with a force greater than 40 lbf (177.9N) at the latch side of the closing stile. It shall
not close through the final 10° in less than 1.5 sec. When the hold open time has elapsed, the operator will
close the door automatically, using spring force and motor. The door will slow to low speed at latch check
before it reaches the fully closed position. The door is kept closed by spring power or extended closing force
by the motor.
Note: Operator should be adjusted for the slowest operation in accordance with Americans with Disabilities Act
(ADA) and ANSI/BHMA A156.19 Standards.
Opening speed: 5 seconds or more
Closing speed: 3 seconds or more
Recommended tools: spring force gauge and stop watch

Double doors

For double doors, the master door must be taught first. The master door will open to the full open position
during the slave door teaching phase.
The doors can also be taught separately before connecting the sync cable (optional).
Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Latch location: 10° or more
Latch speed: 1.5 seconds or more
9
ASSA ABLOY
80-9359-0001-020 (01-14) Rev 3