Advertisement
DC8200 Series
Universal Door Closer
Installation Instructions
D. Mount Adapter Plate
Bracket on Jamb
Using holes spotted on soffit or stop in
Step A, mount adapter plate bracket.
F. Position Arm on Closer
Using hex wrench provided, turn closing speed and latching speed
valves clockwise until completely closed. DO NOT OVER TIGHTEN.
Using wrench, turn under side of spindle 45° toward the closer tube
until it reaches the diamond position (Fig. 2).
Immediately place arm on spindle so that it is parallel to the closer body.
Install and tighten arm screw and
washer assembly. Reopen valves.
G. Connect and Position Arms
Open door and slide arm rod into arm loop. Close door,
swing arms so that they form a "V" position, as in Step H.
With 7/16" wrench, INSTALL AND TIGHTEN SCREW SECURELY.
H. Power Adjustment
To increase the power of the closer, re-adjust the arm so it is
nearer the door. To decrease power, re-adjust the arm so it is
farther away from the door and then secure screw in arm
loop (non-hold open) or elbow joint (hold open).
I. Adjust Door Closer: Refer to Page 8
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2006, 2009, 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY
Access and Egress Hardware Group, Inc. is prohibited.
E. Attach Arm Bracket to Frame
Non-Hold Open Arm Only:
Approved 2022-12-12
Hold Open Arm (A1 Option Only):
1/4-20 x 1/2 POHMS with Patch (2)
Hold Open Arm Only:
Remove main arm screw from elbow joint and disassemble
arm. Thread the rod into the Arm Bracket as shown below.
While door is closed, adjust the Threaded Arm in the Arm
Bracket until the bearing fits back onto the elbow joint on the
Main Arm and forms a "V" as shown below.
RE-INSTALL AND TIGHTEN SCREW SECURELY.
Extended Maintenance
Lubricate Arm periodically at shaded points with a drop or
two of appropriate lubricant.
NOTE: When lubricating a Hold Open Arm, DO NOT use any
lubricant on the Holding Surface components.
5
80-9380-8000-152 Rev 3 12/22
Advertisement
