Removing The Mains/Power Cable (Hard Wired Versions Only); Installing The Mains/Power Cable (Hard Wired Versions Only) - Getinge Arjohuntleigh NIMBUS II Service Manual

Nimbus/DFS Service Manual
29

Removing the Mains/Power Cable (Hard wired versions only)

WARNING: BEFORE REPLACING THE MAINS/POWER CABLE, ENSURE THE PUMP
UNIT HAS BEEN ISOLATED FROM THE MAINS/POWER SUPPLY BY
REMOVING THE MAINS/POWER PLUG FROM THE WALL SOCKET.
29.1 Disassemble the Rear Case (Refer to Chapter 3, Page 5, Section 4).
29.2 Remove the 2 screws and fold back the cable clamp on the integral 5-way connector and
support (Fig 21, Item 10).
29.3 On the 5-way connector (Fig 21, Item 10), loosen the 3 screws on the bottom right-side of the
connector (nearest the corner of the pump case), and remove the live, neutral and earth wires of
the mains/power cable (Fig 21, Item 20).
29.4 Carefully pull the end of the mains/power cable out through the side panel.
30

Installing the Mains/Power Cable (Hard wired versions only)

30.1 Pass the end of the new mains/power cable through the rubber guide in the side panel, and
connect the live, neutral and earth wires to the terminals on the 5-way connector
(Fig 21, Item 10) as shown. Tighten the 3 screws.
Note: The earth wire must be longer than the live and netral wires, so that it will be the last
conductor to be removed from the terminals should the mains cable be pulled.
30.2 Close the cable clamp, on the integral 5-way connector and support (Fig 21, Item 10), over the
insulated part of the mains/power cable, and install the 2 screws to clamp the mains/power cable
in position.
Note: Assemble the rear case (Refer to Page 5, Section 5).
Issue 2
April 2010 SER0001
Pump Repair
Chap 3
Page 37