Safran RTR-NeXt User Interface Manual page 28


Values available for IF Filter bandwidth

Automatic mode is engaged except in FM, FM
S/C, ARTM CPM, and MS FM.

If the increment button is grayed, automatic mode
is selected, else manual mode is active.

IF Filter is read only in ARTM CPM and MS FM.
There are 29 available IF filters :

from 3kHz to 36MHz with a Tuner S

from 3kHz to 40MHz with a Tuner IRIG

Time constant is available if AGC mode is Auto.
There are 5 values available from 0.1 ms to 1 s.

Zeroing command is sent.
Zeroing function described in RX-1 and RTR user
manuals

Left-clicking on this button opens the following
popup window with additional parameters 'see
below)

Check if connected to a RSR equipment
- In replay mode, it is necessary to activate this
menu, so that the AGC information is taken
from J47 connectors on the rear panel of the
receiver.
Nota this menu is active only if the RTR
frequency setting is IF.
© Safran Data Systems – IMP000074 e14r1
Radio Telemetry Receiver
Graphical User Interface Manual
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. D130486
Is.Rev 03
Customer Ref.: -
Date: 21/06/2021
Safran Data Systems
.
Page 28