Table of Contents
Advertisement
Video gan control
4.7.19.1
Video gain management.
The video gain is stored:
In the ctx files
In the mcs files
The video gain only impacts the video outputs.
The eye diagram represents the signal at the input of the bit-sync. Thus, the analog video output could
be saturated and at the same time, the bit sync inputs are not saturated.
Setting the video outputs, there are two situations:
The mission cannot be repeated and the user will have to adjust the video level in live
The mission can be repeated, so the video gain may be set during the preparation of the mission
4.7.19.1.1
The mission cannot be repeated.
This is of course the most difficult situation. In this case, when the mission starts, most of the time, the
video outputs are saturated by noise.
© Safran Data Systems – IMP000074 e14r1
Radio Telemetry Receiver
Graphical User Interface Manual
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref.
D130486
Is.Rev
03
Customer Ref.:
-
Date:
21/06/2021
There is no signal
at the inputs of the
receiver.
The video outputs
are saturated by
the noise
Safran Data Systems
.
Page 152
Advertisement
Table of Contents
