Table of Contents
Advertisement
4.7.16
AGC/AM Output Settings for S109992, S109994, SM01059943A & SM01059948A.
A new feature has been introduced in version E2R7 and higher on some RTR models. This version gives access
to AM outputs directly on Tuner boards.
AM signal is computed directly in the Tuner board and is independent from the AGC time constant. Hence
when using those AM outputs, the AGC time constant can be set to 0.1ms which is recommended.
Moreover, to be accessible, the FW of the Tuner IRIG board should be at least 0.2.0.0 as described on the
following picture. (The version is accessible in the Versions page):
If Tuner version is indicating 0.1.0.x, this function is not available. For upgrade, please contact Safran Data
Systems.
1
Activate output
Load specific settings
Single-Click on the button will open the following
pop-up window to fully configure settings
Signal and Source are displayed dynamically from
the specific settings.
© Safran Data Systems – IMP000074 e14r1
Radio Telemetry Receiver
Graphical User Interface Manual
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref.
D130486
Is.Rev
03
Customer Ref.:
-
Date:
21/06/2021
2
Safran Data Systems
.
Page 147
Advertisement
Table of Contents
