Table of Contents
Advertisement
Note: AGC output configuration with the zeroing function:
By activating the zeroing function on the main page, the noise levels at the inputs of the Pre D
combiner have been balanced, but this has not changed the AGC outputs.
The following Pop-up shows the display of the AGC outputs using the absolute mode.
To set the « 0 » of the AGC to the noise level measured, the AGC is switched to the "Strength mode".
On the following Pop-up:
The AGC low level (0 V) corresponds to the Noise level measured.
The AGC high level (5 V) corresponds to the max level (- 10 dBm).
Nota 1:
The level in the Min case should be the noise level measured and it should be grey so that
the user
could not change it.
Nota 2:
By activating, the AGC mode strength, the user changes the slope of the AGC.
© Safran Data Systems – IMP000074 e14r1
Radio Telemetry Receiver
Graphical User Interface Manual
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref.
D130486
Is.Rev
03
Customer Ref.:
-
Date:
21/06/2021
Safran Data Systems
.
Page 146
Advertisement
Table of Contents
