Table of Contents
Advertisement
About the Analyzer Sample System and Electronics
The sample filtering, flow control, and connection points for the Sample and
Vent Lines are all provided on the backpan (Figure 1-1). The remaining com-
ponents of the sample system – Sample Line, Sample Probe, Vent Line to a low
pressure flare header (or vent to atmosphere) – can be supplied by AMETEK or
by the customer.
Figure 1-1.
Sample system component
layout.
PN 903-8797, Rev A
The temperature of the
analyzer
least 15 °C (27 °F) above the highest expected HCDP temperature of
the sample gas stream. The ambient temperature around the analyzer
and the gas flowing into the Measuring Cell should not exceed 40 °C
(104 °F).
and its sample system must be at
Overview
|
1-3
Advertisement
Table of Contents
Troubleshooting
