Warnings - Respironics BiPAP Focus Operator's Manual

Warnings

Chapter 2: Warnings
WARNING: To avoid the risk of fire, use this device in well-ventilated
areas away from flammable anesthetics. Do not use in a hyperbaric
chamber or other similarly oxygen-enriched environments.
WARNING: When using the BiPAP Focus System, an alternative
means of ventilation should always be available.
WARNING: To reduce the risk of electric shock, ensure that the AC
power cord is undamaged and always disconnect the device from
AC power before opening the enclosure. To ensure that AC power is
disconnected, always disconnect the mains supply at the wall
outlet.
WARNING: The BiPAP Focus System should not be used adjacent to
or stacked with other equipment. If adjacent use is necessary, the
BiPAP Focus System should be observed to verify stable orientation
and normal operation.
WARNING: To minimize the risk of overheating the device, do not
operate adjacent to heaters or other heat sources.
WARNING: The patient should be disconnected if operating in any
mode other than Normal operating mode.
WARNING: Failure to enter Standby mode before switching the ON/
OFF switch on the back of the unit to the OFF position (O) will cause
the unit to alarm for two minutes indicating the unit was not
powered off correctly. This is a safety feature. If it occurs, turn the
unit back ON ( | ) in Normal mode and then shut it down correctly.
WARNING: Medical electrical equipment requires special
precautions regarding electromagnetic compatibility (EMC) and
must be installed and put into service according to the EMC
information provided in this user manual.
WARNING: All components of the breathing circuit are intended for
single patient use only: do not attempt to sterilize or reuse. Follow
all applicable federal and local regulations for disposal or recycling.
®
3
BiPAP Focus™ Noninvasive Ventilator System
1027404 Rev K