Table of Contents
Advertisement
Warnings
WARNING: When running on battery, the high flows that occur
during a patient disconnect will cause the battery to deplete in as
little as 2 minutes. Connect AC power immediately if the Battery
Depleted Alarm sounds to avoid total loss of power.
WARNING: To avoid the risk of electrical shock, do not touch the
communication
ports
on
the
ventilator
and
the
patient
simultaneously.
WARNING: Do not perform the Preoperational Check with a patient
attached.
WARNING: To avoid the risk of electrical shock, this equipment
must only be connected to AC mains with protective earth.
WARNING: The AC power mains outlet used for the ventilator shall
be easily accessible by the operator. This is to provide the ability to
disconnect the BiPAP Focus system from electrical mains if this
should be necessary.
WARNING: The DC power supply provided with the BiPAP Focus
system is part of the equipment. Use only the DC power supply
approved for use with the BiPAP Focus system. Failure to use the
approved DC power supply can result in improper operation or
failure of the BiPAP Focus system.
WARNING: Do not remove the power cord retaining clip from the
device.
WARNING: If placing the BiPAP Focus System on a flat surface or
the stand, ensure that the surface is stable.
WARNING: To prevent possible patient injury, verify that the battery
is fully charged before putting a patient on the ventilator and before
unplugging the ventilator for transport or other purposes. The
battery is fully charged when the BATTERY CHARGING light is off
while the ventilator is connected to AC power.
WARNING: Do not use the BiPAP Focus for physical support.
WARNING: Stow the machine, patient circuits, power cords and
accessories safely when not in use.
®
6
BiPAP
Focus™ Noninvasive Ventilator System
1027404 Rev K
Advertisement
Table of Contents
