Table of Contents
Advertisement
Setup
45 minutes at default settings (see "Specifications" on page 67 for default
settings).
The internal battery charging cycle is active whenever the system is
connected to AC power and the back panel ON/OFF switch is ON ( | ) and
the BATTERY CHARGING LED is illuminated.
BiPAP Focus
System
NOTE: The BiPAP Focus System is shipped with the battery
disconnected. The battery must be connected before the BiPAP Focus
System will operate. Connect battery during initial setup (see page 11).
NOTE: If the unit is being set-up for the first time (out of the box), it is
recommended that the unit gets a full battery charge. This also applies
after the unit has been stored for 2 weeks or longer.
NOTE: For maximum battery performance, a new battery or a battery that
has been in storage should be fully charged and discharged two to three
times.
14
DC power supply
Figure 5: Connecting to AC (Wall) Power
BiPAP
ON/OFF switch
DC power supply
connection and
retaining clip
To AC power
®
Focus™ Noninvasive Ventilator System
1027404 Rev K
Advertisement
Table of Contents
