Chapter 3: Setup
When unpacking the BiPAP Focus System, ensure that all parts listed on
the packing list are included in the shipment. Inspect all parts for damage
before use, and immediately report any discrepancies to your Respironics
representative.
System Components
The BiPAP Focus System includes the ventilator, a DC power supply with
mains (AC) power cord, and a reusable inlet filter.
Setup
WARNING:
• Set up the device so that cables and hose do not pose a
tripping hazard. Do not use the device for physical support if
moving a person.
• Use proper technique for lifting the device.
• Use Respironics-approved patient circuits and interfaces only.
• Lift the unit as shown in Figure 1. Do not lift the unit by the
inlet filter at the rear of the unit or by the front panel.
®
BiPAP
Focus™ Noninvasive Ventilator System
1027404 Rev K
Setup
9