Setup
Lifting the BiPAP Focus Unit
CAUTION: Lift the unit as shown in Figure 1. Do not lift the unit by
the inlet filter at the rear of the unit or by the front panel.
Figure 1: Lifting the BiPAP Focus Unit
After removing all packaging materials, remove the protective plastic
cover from the display, and wipe the exterior of the BiPAP Focus clean
with a damp cloth and mild detergent solution before the first use (see
"Care and Maintenance" on page 57). Also clean the ventilator exterior
between each patient use and as needed.
The BiPAP
Focus
Ventilator is shipped with the battery disconnected.
®
™
The battery must be connected before the BiPAP Focus Ventilator will
operate. Connecting the battery is a routine action, therefore a qualified
service technician is not required. Follow these simple steps to connect
the battery:
1. Ensure that the ON/OFF switch is in the OFF position (O) and
that the power cord is disconnected.
®
10
BiPAP
Focus™ Noninvasive Ventilator System
1027404 Rev K