Replacing A Usb Embedded Hypervisor Flash Device; Removing A Hot-Swap Power Supply - IBM x3690 X5 Service Manual

Replacing a USB embedded hypervisor flash device

To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Align the USB flash device with the connector on the x8 low-profile riser-card
3. Slide the lockbar toward the riser-card assembly to the locked position until it
4. Reconnect the power cord and any cables that you removed.
5. Install the cover (see "Replacing the server top cover" on page 265).
6. Slide the server into the rack.
7. Turn on the peripheral devices and the server.

Removing a hot-swap power supply

When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
324
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
"Installation guidelines" on page 261.
assembly and push it into the connector until it is firmly seated.
is seated firmly.
USB Hypervisor
key
Lockbar