IBM x3690 X5 Service Manual page 34

v Locator LED: Use this LED to visually locate the server among other servers.
v Video connector: Connect a monitor to this connector. The video connectors on
v Serial connector: Connect a 9-pin serial device to this connector. The serial port
v USB connectors: Connect a USB device, such as a USB mouse, keyboard, or
v Systems-management Ethernet connector: Use this connector to connect the
v QPI link LEDs
v Ethernet activity LEDs: When these LEDs are lit, they indicate that the server is
v Ethernet link LEDs: When these LEDs are lit, they indicate that there is an
v Ethernet connectors: Use either of these connectors to connect the server to a
16
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Flashing rapidly (4 times per second): The server is turned off and is not
ready to be turned on. The power-control button is disabled. This lasts
approximately 1 to 3 minutes.
Flashing slowly (once per second): The server is turned off and is ready to
be turned on. You can press the power-control button to turn on the server.
Lit: The server is turned on.
Fading on and off: The server is in a reduced-power state. To wake the
server, press the power-control button or use the IMM Web interface. See
"Logging on to the Web interface" on page 413 for information about logging
on to the IMM Web interface.
You can use IBM Systems Director to light this LED remotely. This LED is
functionally equivalent to the locator LED on the front of the server.
the front and rear of the server can be used simultaneously.
Note: The maximum video resolution is 1280 x 1024 at 75 Hz.
is shared with the integrated management module (IMM). The IMM can take
control of the shared serial port to perform text console redirection and to
redirect serial traffic, using Serial over LAN (SOL).
other device to any of these connectors.
server to a network for full systems-management information control.
When these LEDs are lit, they indicate that there is an active link connection to
the MAX5 or another x3690 server.
transmitting to or receiving signals from the Ethernet LAN that is connected to
the Ethernet port.
active link connection on the 10BASE-T, 100BASE-TX, or 1000BASE-TX interface
for the Ethernet port.
network. When you use the Ethernet 1 connector, the network can be shared
with the IMM through a single network cable.