Replacing The Front Usb Connector Assembly - IBM IntelliStation A Pro 6217 Service Manual

Figure 39. Front USB connector assembly replacement
9. From the inside of the chassis, place your fingers on the two tabs on the front

Replacing the front USB connector assembly

Note: When replacing the front USB connector assembly:
1. Route the cable so that it does not impede movement of the drive cage.
2. It might be helpful to use a flat-blade screw driver from the outside to help snap
To install the front USB connector assembly, complete the following steps:
USB connector assembly and squeeze them together to detach the assembly
from the computer; then, pull the assembly toward the inside of the chassis and
remove it.
the connector into place.
1. Touch the static-protective package containing the front USB connector
assembly to any unpainted metal surface on the computer. Then, remove the
front USB connector assembly from the package.
2. From inside of the chassis, slide the front USB connector assembly forward
through the front panel (while at the same time squeezing the two tabs on the
sides of the assembly) until the assembly snaps into place on the chassis.
3. Route the front USB connector assembly cable and connect it to the system
board.
Chapter 4. Removing and replacing computer components
133