Removing 2.5-Inch And 1.8-Inch Hot-Swap Drives - IBM x3690 X5 Service Manual

4. Install the riser-card assembly in the server (see "Replacing a PCI riser-card
5. Perform any configuration tasks that are required for the adapter.
6. Install the cover (see "Replacing the server top cover" on page 265).
7. Slide the server into the rack.
8. Reconnect the power cord and any cables that you removed.
9. Turn on the peripheral devices and the server.

Removing 2.5-inch and 1.8-inch hot-swap drives

To remove a hot-swap drive, complete the following steps.
Attention:
v To avoid damage to the drive connectors, make sure that the server cover is in
v To make sure that there is adequate system cooling, do not operate the server for
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. Removing a 2.5-inch hot-swap drive:
278
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Adapters
PCI
riser-card
assembly
assembly" on page 337).
place and fully closed whenever you install or remove a drive.
more than 2 minutes without either a drive or a filler panel installed in each bay.
and "Installation guidelines" on page 261.
a. Slide the release latch (orange) up gently to unlock the drive handle
PCI
riser-card
assembly
PCI slots