IBM x3690 X5 Service Manual page 343

Hide thumbs Also See for x3690 X5:

Table of Contents

Never remove the cover on a power supply or any part that has the following

label attached.

Hazardous voltage, current, and energy levels are present inside any component

that has this label attached. There are no serviceable parts inside these

components. If you suspect a problem with one of these parts, contact a service

To remove a hot-swap power supply, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

and "Installation guidelines" on page 261.

2. If only one power supply is installed, turn off the server and peripheral devices

and disconnect all power cords.

3. If the server is in a rack, at the back of the server, pull back the cable

management arm to gain access to the rear of the server and the power supply.

4. Press and hold the orange release tab to the left. Grasp the handle and pull the

power supply out of the server.

Chapter 5. Removing and replacing components