Removing An Adapter - IBM x3690 X5 Service Manual
Hide thumbs
Also See for x3690 X5:
- Installation and user manual (180 pages) ,
- Product manual (42 pages) ,
- At-a-glance manual (34 pages)
Table of Contents
Advertisement
7. Turn on the peripheral devices and the server.
Removing an adapter
To remove an adapter, complete the following steps:
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. Turn off the server (see "Turning off the server" on page 17) and all attached
3. Remove the server cover (see "Removing the server top cover" on page 264).
4. Disconnect any cables from the adapter.
5. Grasp the riser-card assembly by the blue touch points and pull it out of the
6. Carefully grasp the adapter by its top edge or upper corners, and pull the
7. Place the riser-card assembly on a flat, static-protective surface.
8. If you are instructed to return the adapter, follow all packaging instructions,
274
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
and "Installation guidelines" on page 261.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
connector on the system board.
adapter from the riser-card assembly.
and use any packaging materials for shipping that are supplied to you.
Advertisement
Table of Contents
