Table of Contents
Advertisement
9. If there is a jumper harness attached to the wire bundle, it identifies the fuser width
restriction / resistance. One of two resistance jumpers may be installed. No jumper
(this is the default) indicates that the standard fuser is installed. Disconnect the four
Fuser connectors:
a) Pinch the tabs on both sides of the black connector and lift to remove.
b) Using a Torx driver, gently push the tabs in on each of the three white connectors
while pulling slightly on the wires to remove.
c) Release the wire bundle from the harness clip.
10. Locate the storage area of the press that holds the pack of Fuser and Pressure Roll
Lift Handles. Remove the Lift Handles pack from the storage area.
11. Place the Fuser Belt Module Handles on the posts on each end of the module.
12. Facing the right side of the drawer, push the module slightly away from you and lift
the Fuser Belt straight up and out of the press, letting the weight of the module hang
in your hands.
Note
Do not twist or rotate the module as you place it in the Holding Rack.
13. Place it on the Fuser Holding Rack provided. Align the edge of the roller to the scribe
mark on the holding rack frame.
®
®
Xerox
Versant
2100 Press
User Guide
Maintenance
9-21
Advertisement
Table of Contents
