Xerox Versant 2100 User Manual page 123

Fault Area Fault Code
Door 048-300
Decurler 048-310, 048-311,
048-312, 048-313,
048-314, 048-315,
048-316
Cooling 048-317, 048-318,
048-319
Communica- 048-320 to 048-
tion 324
Paper Path 048-900, 048-901,
048-903
Fault Codes - GBC AdvancedPunch
Fault codes for the GBC AdvancedPunch are displayed on the press User Interface /
Control Panel as an AdvancedPunch fault code.
Fault Code Cause
040-100 Jam is detected in the Advanced-
040-101 Punch.
040-900
040-901
040-300 Front door of the Advanced-
Punch is not closed.
040-940 The punch die set is missing or
not fully installed.
040-941 Punch container is missing or
not fully installed.
040-942 Punch container is full.
® ®
Xerox Versant 2100 Press
User Guide
Possible Cause
Module front door is open
Decurler Sensor or Belt issue
Cooling fan failure
Communication failure or
connection failure
Sheets remain in the paper
path area
Remedy
1. Open AdvancedPunch front door
and look for a paper jam.
2. Remove any paper jam.
3. Close front door.
Close front door of the AdvancedPunch.
Install punch die set or fully insert it; close
front door.
Install and / or fully insert punch container;
close front door.
Empty punch container and then reinstall
it.
Problem Solving
Recommended Solution
Ensure door is fully closed.
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Ensure all jams are cleared;
Ensure all handles/levers are
returned to closed position;
Power Off/On the press
Open the Module front door.
Remove all sheets or pieces
from all paper path areas.
Close the front door. Verify
that the paper being used is
within specifications.
10-21