Xerox Versant 2100 User Manual page 183

Punch Cycles
This is the total number of punched sheets the system has processed.
Die Cycles
This is the total number of sheets punched with the currently installed die-set.
Firmware
This displays the current level of firmware on the AdvancedPunch Pro.
Die Sets
Die Set Configuration
The die sets for the AdvancedPunch Pro are intended to work with multiple paper sizes
and feed directions. In order to accommodate different sheet sizes the die set must be
configured to the correct number of punching pins, and the die stop must be set to the
proper position. The die label contains information on the common paper punching
sizes. For the uncommon sizes, refer to these two tables:
Sizes and Pin Removal Table for ISO Paper
Pin Numbering
Die punching pins are numbered sequentially starting from the handle end. The following
illustration shows a 47-hole coil die set as an example; the Pin Number 1 and Pin Number
47 (last pin) locations are indicated in the illustration.
Note
All square and round hole die sets follow the same pin numbering format.
Tables Pin Removal Table for US Paper Sizes
show the information on which pins need to be removed to correctly punch each sheet
size and configuration that the AdvancedPunch Pro can accept. For standard-offering
dies that are not found in the chart no pin adjustment is necessary.
® ®
Xerox Versant 2100 Press
User Guide
GBC AdvancedPunch Pro
Pin Removal Table for US Paper
Sizes.
and Pin Removal Table for ISO Paper Sizes
14-7