Table of Contents
Advertisement
1. Select the arrow buttons to decrease or increase the trimmer setting. Adjustments
are made in 0.1 mm/0.0039 inch increments.
2. The trimmer setting is based on:
• The number of sheets in the finished booklet
• The finished booklet width size
• The media type (coated or uncoated)
• The media weight
Note
Experiment with various settings to determine the best selections for your job. You may
want to run one or more test prints before running larger jobs for best booklet output.
Note
Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20
mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm may
produce poor trim quality. Adjustments greater than 20 mm result in no trimming to
the booklet edge.
Trim Guidelines
The following table shows various scenarios using different paper weights, media types,
and trim setting selections. Use this table as a guideline when selecting a trim setting
for your specific job.
Note
The settings shown in the following table are provided as examples and are not meant
to represent every possible job scenario; again, use this table as a guideline only.
Scenario
Paper Size
number
8.5 x 11 in. / A4
1
(210 x 298 mm)
®
®
Xerox
Versant
2100 Press
User Guide
Finished booklet
Paper weight
size
(lbs. / gsm)
5.5 x 8.5 in. / 149
20 lbs. / 75
x 210 mm
gsm
SquareFold Trimmer Module
Number of
Approximate
pages in
trim setting
finished
(mm)
booklet
130
20
17-7
Advertisement
Table of Contents
