Table of Contents
Advertisement
Standard Finisher / Booklet Maker Finisher
Fault code
Possible cause
024-980
The stacker tray is full
024-981
The top tray is full
024-982
The Finisher stacker tray
lower safety warning is on
024-983
The Finisher Booklet tray is
full
024-984, 024-985
The Booklet stapler low staple
signal is on
024-987, 024-988
The Booklet folder tray is full
047-320
A communication error has
occurred with the Finisher
112-700
The Punch Waste Container
is full or near full
116-790
The settings for stapling are
canceled and prints the data
124-705
The settings for punching are
canceled
124-706
The settings for folding are
canceled
124-709
The number of pages exceeds
the number of pages that can
be stapled
16-16
Recommended solution
Remove all paper from the stacker tray.
Remove all paper from the Finisher top
tray.
Remove all paper from the stacker tray
and remove any other obstructions.
Remove all paper from the Booklet tray.
Remove all paper from the Booklet tray.
Remove all paper from the tray. Set the
output tray for three-fold. Check that the
folder tray is correctly attached and set.
Power Off/On the press. Resend the print
job if needed. If fault persists, contact
Customer Support Center.
Remove and empty the waste container
and then reinstall it completely.
Confirm the staple position and try to
print again.
Confirm the punching position and try to
print again.
Confirm the folding settings and try to
print again.
Decrease the number of pages, or cancel
the stapling settings. Resend the print job.
®
Xerox
Versant
®
2100 Press
User Guide
Advertisement
Table of Contents
