Xerox Versant 2100 User Manual page 129

Fault code Possible cause
013-940 The Trimmer Waste Contain-
er is full or has a fault
Fault Codes - Standard Finisher Plus
If a fault occurs in the Standard Finisher Plus, a fault message displays. The following
table provides a list of fault codes for this finisher module and of related Transport and
3rd party DFA fault codes.
Fault Code Possible Cause
013-108 to 013-110 The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time
013-910, 013-911 Paper jam at the transport
sensor or exit sensor (Finishing
Transport)
051-100 to 051-111, Paper jam
051-900
051-210 Registration clutch solenoid
fault
051-211 Diverter solenoid fault
® ®
Xerox Versant 2100 Press
User Guide
Problem Solving
Recommended solution
• Pull open the container and empty any
trimmer scraps from it.
• Reinsert the container into the module.
• Make sure the container is pushed in
completely.
• If fault persists, power off/on the press.
• If fault persists, call for service.
Recommended Solution
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center.
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center.
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center.
Power Off / On the press and resend the
print job. If the fault persists, contact the
Customer Support Center.
Power Off / On the press and resend the
print job. If the fault persists, contact the
Customer Support Center.
10-27