Table of Contents
Advertisement
High Capacity Stacker (HCS)
5. Remove the securing bar.
6. Remove the paper from the Stacker Tray.
7. Push the empty Stacker Cart straight into the HCS.
8. Position the securing bar on the fixed area inside the HCS.
9. Close the front door; the tray will rise to the operate position.
HCS Media Guidelines
• Stacker Tray will accept 52-350 gsm (either coated or uncoated stock) with the
possibility of degraded stock quality and increased jam rate for stocks that are heavier
than 300 gsm.
• Transparencies may be run to either the Top Tray or the Stacker Tray. Stack height
should be limited to 100 transparencies.
• Coated paper lighter than 100 gsm may not run as reliably as coated paper heavier
than 100 gsm.
• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210
mm (8.3 in.) minimum measurement across the feed direction.
• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require
330 mm (13 in.) minimum measurement in the feed direction.
Problem Solving
Fault Codes - High Capacity Stacker
This fault code table lists problems and suggested solutions that apply to the High
Capacity Stacker (HCS).
Important
The press configuration can be installed with one or two stacker modules. If the press
includes two HCS modules, the prefix 049 identifies a fault in the first module and 149
identifies a fault in the second module.
Fault Code
Possible Cause
049-100 to 049-121
jammed paper
049-2[00-99]
HCS sensor faults
049-300
HCS communication fault
15-4
Recommended Solution
Carefully remove all sheets and paper
scraps from the jam clearance areas.
Power Off/On the machine. If the
problem persists, contact the Customer
Support Center.
Power Off/On the machine. If the
problem persists, contact the Customer
Support Center.
®
Xerox
Versant
®
2100 Press
User Guide
Advertisement
Table of Contents
