Table of Contents
Advertisement
P
F
J
REPARATIONS
OR
ACKING
1.
Park the vehicle on a firm, level surface. Avoid ice or
slippery areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid being hit when operating the jack or
changing the wheel.
2.
Turn on the Hazard Warning Flashers.
3.
Apply the parking brake.
4.
Shift the transmission into PARK (P).
5.
Turn the ignition OFF.
6.
Block both front and rear of the wheel diagonally
opposite of the jacking position. For example, if the
driver's front wheel is being changed, block the
passenger's rear wheel.
Wheel Blocked Example
NOTE:
Passengers should not remain in the vehicle when the
vehicle is being raised or lifted.
J
L
ACK
OCATION
The jack and tools are stored under the front passenger
seat.
R
O
J
A
T
EMOVAL
F
ACK
ND
OOLS
To access the jack and tools, you must remove the plastic
access cover located on the side of the front passenger's
seat. To remove the cover, pull the front part of the cover
(closest to the front of the seat) toward you to release a
locking tab. Once the front of the cover is loose, slide the
cover toward the front of the seat until it is free from the
seat frame.
Jack Access Cover
IN CASE OF EMERGENCY
Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then slide the
assembly out from under the seat.
Wing Bolt/Jack And Tools
Remove the jack and tools from the bracket assembly.
Turn the jack turn-screw counterclockwise to release jack
from bracket assembly.
Jack And Tools Bracket Assembly
353
7
Advertisement
Table of Contents
