Table of Contents
Advertisement
3.
Pass the tether strap hook under the head restraint
behind the child seat, through the tether strap loop
behind the seat and over to the right or left outboard
tether strap loop.
Tether Strap Through Center Tether Strap Loop
4.
Attach the hook to the outboard tether strap loop (see
diagram). Tighten the tether strap according to the
child seat manufacturer's instructions.
Tether Strap Through Center Tether Strap Loop And Attached
To Outboard Tether Strap Loop
Installing Three Child Restraints:
1.
Place a child restraint on each outboard rear seat.
Route the tether straps following the directions for
right and left seating positions, above.
2.
Attach both hooks to the center tether strap loop, but
do not tighten the straps yet.
3.
Place a child restraint on the center rear seat. Route
the tether strap following the directions for the center
seating position, above.
4.
Attach the hook to the outboard tether strap loop.
5.
Tighten the tether straps according to the child seat
manufacturer's instructions, tightening the right and
left tether straps before the center tether strap.
Outboard And Center Seating Positions Shown
WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchorage position directly behind
the child seat to secure a child restraint top tether
strap.
If your vehicle is equipped with a split rear seat,
make sure the tether strap does not slip into the
opening between the seatbacks as you remove slack
in the strap.
SAFETY
345
6
Advertisement
Table of Contents
