Tilt Side Mirrors In Reverse; If Equipped; Power Convex Mirror Switch; Forward Utility Lights And Rear Guidance Lights - RAM 2500 2023 Owner's Manual

44 GETTING TO KNOW YOUR VEHICLE
T S M I R
ILT IDE IRRORS N EVERSE
I E
F QUIPPED
This feature provides automatic outside mirror positioning
which will assist with the driver's ground visibility. The
outside mirrors will move slightly downward from the
present position when the vehicle is shifted into REVERSE.
The outside mirrors will then return to the original position
when the vehicle is shifted out of REVERSE. If the vehicle
is equipped with Driver Memory Settings, this feature will
be linked to the programmable settings.
NOTE:
The Tilt Side Mirrors In Reverse feature can be turned on
and off using the Uconnect system
Ú
P C M
OWER ONVEX IRROR
I E
F QUIPPED
The Power Convex Mirror Switch is located on the door
trim panel, above the power mirror controls. The switch
enables the movement of the convex portion of both the
driver and passenger outside mirrors.
—
To adjust the convex portion of the outside mirrors, push
page 226.
the Power Convex Mirror Switch. Then, select the mirror
you want to adjust by using the L (left) or R (right) buttons.
S —
WITCH
Using the mirror control switch, push any of the four
arrows for the direction you want the mirror to move.
To return the control to the large mirror, push the Power
Convex Mirror Switch a second time.

Power Convex Mirror Switch

Trailer Tow Power Convex Mirror
NOTE:
If the Power Convex Mirror Switch is not pushed a second
time, the switch will automatically default back to the
larger portion of the outside mirrors after a period of time.
F U L
ORWARD TILITY IGHTS AND
G L — I E
UIDANCE IGHTS F QUIPPED
The forward utility lights and reverse guidance lights
switches are located on the drivers door trim panel, above
the power mirror controls. These switches enable the
forward or reverse lights located on the driver and
passenger outside mirrors.
Forward and Reverse Light Switches
When either button is pressed the corresponding light on
the outside mirror will remain on for ten minutes. The
vehicle must be in the ON/RUN or ACC position. When the
light is active, the switch on the door panel will illuminate.
Pushing the switch a second time will turn the lights off.
R
EAR